64x32 LED Matrix w/ Pi Housing by Knifa - Thingiverse
This is a two-part housing for a cheap 64x32 LED matrix, including mounting for a Raspberry Pi 3A+https://www.youtube.com/watch?v=u022jF8vcOcBOM1x 192x96mm LED panel like this one. Unfortunately, this listing makes no guarantee of screw hole locations, however I've ordered several panels and they have all been the same so far.1x 198x102mm acrylic piece for the front.1x Raspberry Pi 3A+1x XT30 for power.6x M3-10mm button-head screws.2x M3 nuts.Build NotesTo get the Pi to fit, you will need to remove the large power connector and solder cables on directly.The Pi sits upside down, facing into the matrix.The Pi mount is offset a little bit to clear some capacitors if you are using a makeshift hat.The screws pass through the back casing, through the front casing, and into the LED matrix, holding the whole thing together.The acrylic piece should press fit in. You might need to sand it a little!Use this library to start displaying things: [rpi-rgb-led-matrix](https://github.com/hzeller/rpi-rgb-led-matrix/}.
Explore this link on the map →